On Saturday 03 January 2009, David Braley wrote: >Here is another source for the same motor: >http://www.gazaur.com/twe/index.php?cPath=3 > >It appears they sell the controller as well: >http://www.gazaur.com/twe/product_info.php?products_id=322 > Yes, it clarifies the pricing as being rather heavy duty at $200 for one motor and controller. Scarey even. I think I'd use a 22k rpm trim router, belted to a separate spindle geared up about 3/1. Slender o-rings for belts, several of them. I think I could do it for less money, and a longer service life.
>I hope this helps. > >Dean Hedin wrote: >> Take this one for example: >> >> http://www.hobby-lobby.com/brushless-gazaur.htm >> >> The R/C motors are rated with "Kv". Which means rpms per volt with no >> load. The above motor is rated at 4100kv and can go up to 12volts. >> So that would be 49200 rpm. >> >> If you want to seach google again try "R/C Brushless Motors" >> >> Be advised you will require a special controller/driver for these motors. >> >> ----- Original Message ----- >> From: "Gene Heskett" <[email protected]> >> >>> Unforch, I just spent 15 minutes googling for those, and found absolutely >>> zero real information on those motors. And I don't buy pigs in a poke I >>> can't see through. >> >> -------------------------------------------------------------------------- >>---- _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users > >---------------------------------------------------------------------------- >-- _______________________________________________ >Emc-users mailing list >[email protected] >https://lists.sourceforge.net/lists/listinfo/emc-users -- Cheers, Gene "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Grange: "We can go to 25." Mal: "Well... we'll be taking a loss. But you seem like clean and virtuous boys. Done." --Episode #5, "Safe" ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
