General questions are the hardest to answer. They are even harder to answer when your not asking about the subject of the mailing list.
Best plasma torch or best price... pick any one. I use a Hypertherm 1250 and it was the best one for me. You have to figure out the best one for you. MUCH more info is on the cnczone in the plasma cutting forum than the EMC mailing list. Do a search for Jim Colt and read all of his replies. You will get a wealth of information on plasma cutters from reading his posts. John On 25 Dec 2008 at 11:25, [email protected] wrote: > Which Torch can cut the narrowest and most accurate cut? > I know the width of cut is dependent on cutting gas pressure, but > I > would be pretty sure that an inverter type power source would also > give > narrower cuts than a transformer based source due to the higher > frequency used. The width of cut depends on the nozzle, amps, material type, material thickness for the most part. Why do you want to know how narrow a cut can be done? Too close of a detail and the parts between cuts simply melt out from the heat unless your cutting under water... > > So in general; > 1) What is the narrowest I can go, and how do I achieve it. High Definition Plasma > 2) What is the difference in cutting width between air only cutters > and > full shielding and cutting gas torches. About $75,000 > 3) I have a free Miller Syncrowave 200 TIG free, is it possible to > use > the TIG as the power source? No, unless you want to weld with it. > I cannot see why not, voltage is voltage and current is current and > the > TIG can deliver what the torch power sources can too. > 4) As I have a CNC table free I can use to automate the process, > the > holdup for me is to select the best Torch at the best price. > > thanks > > -------------------------------------------------------------------- > ---------- > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
