Richard Acosta wrote:
> OK, i have tried with ted hyde's samples and i got an error, then
> everyone went to laugh on me, because y was using 2.2.6 instead 2.2.7
> ... wich nowhere says i had to use... Off course, as i "apt-get update"
> and never found updates i tought i was using the last version, which was
> told as necessary.
Nobody laughed at you Richard. Ted's config uses features in 2.2.7, and
you were gently informed of this fact.
"apt-get update" only fetches the list of available packages, it doesn't
install anything. The apt-get manpage describes this clearly.
When you ran this, do you know if it downloaded the updated package list
from linuxcnc.org? That would be useful information to have to help us
debug your problem.
> OK, i go linuxcnc page, then check on "how to" install from cvs, well,
> config'd it, downloaded it... then ./configure --enable-run-in-place as
> instructed.
> And, got the following error "c compiler can't create executable"...
> tryed to run it as root also.
> The folder source is at my home folder.
>
>
> ¿What now?...
That is an error from configure. It usually means you dont have a C
compiler installed.
Did you install build-essential, like the wiki page says?
But really, I think this is the wrong way for you to fix your problem.
I think you'd be better off installing the 2.2.7 .deb.
--
Sebastian Kuzminsky
One of my most productive days was throwing away 1000 lines of code.
-- Ken Thompson
-------------------------------------------------------------------------
This SF.Net email is sponsored by the Moblin Your Move Developer's challenge
Build the coolest Linux based applications with Moblin SDK & win great prizes
Grand prize is a trip for two to an Open Source event anywhere in the world
http://moblin-contest.org/redirect.php?banner_id=100&url=/
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
