Hi Jaime I've been pushing for the release for a couple weeks and they finally got it ready. I've downloaded it but not tested the final version. I'm sure that it should be good.
Try it first in live boot mode and see how it works. If it seems to be okay then install it. Hope this helps Ray On Fri, 2008-05-16 at 00:38 +0200, Jaime Alemany wrote: > Hi Ray, > > and thanks! This all happened today or you managed to make it run with > the older version? No need to answer just sheer curiosity... felt > crazy with all the references to Dapper in the linuxcnc.org page until > I read the message announcing the release. > > Will try tomorrow morning, hopefully I'll solve my latency issues > changing the machine. > > Thanks again, > > jaime > > On Thu, May 15, 2008 at 2:04 PM, Ray Henry <[EMAIL PROTECTED]> wrote: > > Hi Jaime > > EMC2 version 2.2.5 is running here on a couple machines with > Hardy. The > python version on both is 2.5.2. I did install from the > EMC2-CD > > http://www.linuxcnc.org/hardy/ubuntu-8.04-desktop-emc2-aj07-i386.iso > > for the last one but used the install script from linuxcnc.org > for the > first. > > http://www.linuxcnc.org/hardy/emc2-install.sh > > I had to execute the commands in that script line by line > because it > didn't want to just run all by itself. It did get past the > fix of the > apt sources but then died someplace. > > Rayh > > > > ------------------------------------------------------------------------- > This SF.net email is sponsored by: Microsoft > Defy all challenges. Microsoft(R) Visual Studio 2008. > http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ > _______________________________________________ Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
