I think so... (a dream). I have a K1 now, and have had a few of them in the past. There can only be 1 band board in at a time, although the K1 will remember the VFO calibration for all the bands, across the boards you have. The only time this is an issue is if you have two different modules with the same band, like 40/30/20/15 on a 4 band board, and 40/17 on a 2 band board.
GL, Bruce N1RX ________________________________________ From: James Rodenkirch [mailto:[email protected]] Sent: Monday, January 19, 2015 10:35 AM To: Bruce Beford; [email protected] Subject: RE: [Elecraft] Found a K1! Bruce: don't consider this the beginning of an argument but.....I recall having both modules installed, at the same time, in my previous K1......was I dreaming that?? > From: [email protected] > To: [email protected] > CC: [email protected] > Subject: Re: [Elecraft] Found a K1! > Date: Mon, 19 Jan 2015 10:08:46 -0500 > > > Going to have the two band module changed to 80/17 and, when not > > traveling, will swap out the ATU for the two band module and have an > > 80/40/30/20/17/15 rig (already have an auto tuner at the base of my 30' > > vertical). > > Jim, > since you had a K1 in the past, you probably remember this, but others may > not be aware... You cannot "swap out the ATU for the 2 band board". The ATU > does need to be removed to replace the 4 band board with the 2 band board as > the band board sits below the ATU in a "stacked" configuration". But- both > band boards cannot be in at the same time. > > As I say, I am pretty sure you know this, but wanted to mention it for the > benefit of others who may not know. > > 72, > Bruce N1RX > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
