No, the mic cables I got plug in the back of the k3/100 and the k3/0. I discovered the problem *may* be that I was using the XMIT button on the k3/0. It seemed to work using the ptt on the mic. I always use the XMIT to key the radio. Using XMIT button did key the radio but there was no audio. I have the k3/100 and k3/0 sitting next to each other so I can see everything that happens. But I was called away by xyl to do something out of house with her just then and could not test thoroughly.
Also when I key the mic ptt switch the 0 goes into cw for a few seconds but the 100 stays on sb. But this does not seem to cause any real problem. Thanks. Eric W1NEJ Sent from my Apple iPhone On Jun 9, 2012, at 3:42 PM, D Joyce <[email protected]> wrote: > Eric: > If you are using the factory cables RRK0CBL, then the microphone (MH2) plugs > into the front panel of the K3/0, so I think you need to set the MIC SEL to > fP.L (or H) > > 73, Doug VE3MV > > ----- Original Message ----- From: "Eric Jorgensen" <[email protected]> > To: <[email protected]> > Sent: Saturday, June 09, 2012 2:47 PM > Subject: [Elecraft] K3/0 > > >> Got my K3/0 and RemoteRigs this morning. >> >> Everything works perfectly except transmit audio. MIC SEL is set to rP.L. >> >> Using factory cables, all set up like the book says they should be. >> >> Any ideas? >> >> Thanks >> >> Eric >> W1NEJ >> >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
