Also forgot to mention that the MH2 needs bias and JMP1 needs to be in place in the Control RRC - see 2nd page of the K3 Twin section of the RRC User Manual.
73, Doug VE3MV ----- Original Message ----- From: "D Joyce" <[email protected]> To: "Eric Jorgensen" <[email protected]>; <[email protected]> Sent: Saturday, June 09, 2012 3:42 PM Subject: Re: [Elecraft] K3/0 > Eric: > If you are using the factory cables RRK0CBL, then the microphone (MH2) > plugs into the front panel of the K3/0, so I think you need to set the MIC > SEL to fP.L (or H) > > 73, Doug VE3MV > > ----- Original Message ----- > From: "Eric Jorgensen" <[email protected]> > To: <[email protected]> > Sent: Saturday, June 09, 2012 2:47 PM > Subject: [Elecraft] K3/0 > > >> Got my K3/0 and RemoteRigs this morning. >> >> Everything works perfectly except transmit audio. MIC SEL is set to >> rP.L. >> >> Using factory cables, all set up like the book says they should be. >> >> Any ideas? >> >> Thanks >> >> Eric >> W1NEJ >> >> >> ______________________________________________________________ >> Elecraft mailing list >> Home: http://mailman.qth.net/mailman/listinfo/elecraft >> Help: http://mailman.qth.net/mmfaq.htm >> Post: mailto:[email protected] >> >> This list hosted by: http://www.qsl.net >> Please help support this email list: http://www.qsl.net/donate.html >> > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
