Hi, thank you very much to OMs who responded to my e-mail. You helped me very much.
Sebastian, W4AS gave the right reference for my HRD -logbook problem. Config: "VFO IND" to Yes. It now works flawless. Rich VE3KI helped me with the Line-in: "With MAIN:MIC SEL set to LINE IN (this is remembered separately for SSB and Data modes), the Mic gain control adjusts the Line In level. " I learned that I have to adjust the level for every mode. So thank you very much, now I can explore all the other funktions of the K3. 73 Oli DL1OLI/AJ4UR -----Original Message----- > Date: Mon, 13 Feb 2012 13:30:34 +0100 > Subject: My new K3 has arrived on Saturday > From: "[email protected]" > To: > 2nd try, first had a html e-mail > > Hello, > my new K3/100F has arrived on Saturday. So I removed my IC-7400 from > the position right to the screen and put it on the left. The IC-7400 > is now my dedicated 6m an 2m SSB/CW radio. On the right sits the K3 > now. > Please have a look: http://files.qrz.com/i/dl1oli/dl1oli_K3_k.jpg > I already had a Ftdi USB-seriell interface and now use this for > control of the K3. I made all of the connections to the PC, Amp, > antennas ect. I even had made cable with the right 3.5 mm connectors > (stereo for speaker/line-out and mono for line/mic in). > I configured Ham-Radio-Deluxe 5 for the K3. > > Now I have two problems: > 1. If I use the DX-cluster in HRD Logbook an click on an dx-entry > which is not on the same band where the K3 is, then the K3 changes to > the new frequency, an directly after it goes back to the old > frequency. For example. The K3 is on 14300 kHz, in the HRD-Logbook > dx-cluster is an entry for 21400 kHz. Then the K3 changes shortly to > 21400 and > immediately goes back to 14300. ? > > 2. The rear line-in does not work. I connected my sound-card to the > line-in with an 3.5 mm mono connector on the radio-end. I used the > MAIN menu to change the source to line in. But tthen it does not > modulate on TX. If I connect the same cable from the sound-card in the > rear microphone instead of line-in, then the K3 modulates. I tried USB > and DATA A modes. The Sound-card and cable is OK because it works in > the rear-mic. ? > > I made some contacts in the CQ WPX-RTTY contest on the weekend. I used > HRD and DM780 for casual contesting. So far it works nicely. I have a > 250 Hz Filter installed and this is very good for strong nearby > RTTY-stations on 40 m. I configured the 250 Hz Filter as a 300 Hz. > > Do you have hints or solutions for my two problems? > > 73 Oli > DL1OLI/AJ4UR > > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
