Oli, Your first problem is probably caused by HRD.
On your second problem, it sounds as if your Line In level is still set to zero. With MAIN:MIC SEL set to LINE IN (this is remembered separately for SSB and Data modes), the Mic gain control adjusts the Line In level. Adjust this control until you see 4-5 bars on the K3's ALC meter. 73, Rich VE3KI DL1OLI wrote: > Now I have =A0two problems: > 1. If I use the DX-cluster in HRD Logbook an click on an dx-entry which > is not on the same band where the K3 is, then the K3 changes to the new > frequency, an directly after it goes back to the old frequency. For > example. The K3 is on 14300 kHz, in the HRD-Logbook dx-cluster is an > entry for 21400 kHz. Then the K3 changes shortly to 21400 and > immediately goes back to 14300. ? > > 2. The rear line-in does not work. I connected my sound-card to the > line-in with an 3.5 mm mono connector on the radio-end. I used the MAIN > menu to change the source to line in. But tthen it does not modulate on > TX. If I connect the same cable from the sound-card in the rear > microphone instead of line-in, then the K3 modulates. I tried USB and > DATA A modes. The Sound-card and cable is OK because it works in the > rear-mic. =A0? ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
