Hi Juan, Be sure to set the K3 configuration that is described in the K3 manual on page 44:
CONFIG:AUTOINF to AUTO 1. I don't have the SDA100 controller but on the older SteppIR controller it is necessary to make both a SETUP change and an OPTIONS menu change to properly activate transceiver tracking. So it is important to read the SteppIR manual carefully. Good luck with your SmallIR. 73, Mike K2MK TG9AJR Juan Munoz wrote > > I have my K3 and just finishing installing my SteppIR small vertical > with the SDA100 Controller > and I also order the K3 Transceiver interface connector from the > SDA100 Controller to the K3. > > Does any one knows how is setp up : > I assume from the DATA IN/RADIO in the SDA100 Controller to the ? on the > K3 ? > > Thank you and 73 > > Juan Carlos Munoz. > TG9AJR > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > -- View this message in context: http://elecraft.365791.n2.nabble.com/K3-SteppIR-Controller-tp7252563p7252769.html Sent from the Elecraft mailing list archive at Nabble.com. ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
