Juan: The SteppIR picture here shows the connections:
http://test.steppir.com/wp-content/uploads/2011/10/Y-Cable.pdf The KPA500 ports are not used for frequency information to the SteppIR. They're used for firmware load of the KPA500, KPA500 operation, and for frequency control with a Kenwood radio. 73 de Dick, K6KR -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of TG9AJR Juan Munoz Sent: Friday, February 03, 2012 3:26 PM To: Elecraft List Subject: Re: [Elecraft] K3 SteppIR Controller Sorry, forgot to mention that besides the K3 I also have hooked the P3 and KPA500 and the RS232 to USB for my computer. Do have available the ports on the KPA500, all the other ports on the K3 and P3 are in used. Thanks. Juan Carlos Munoz. TG9AJR On Fri, Feb 3, 2012 at 5:01 PM, TG9AJR Juan Munoz <[email protected]> wrote: > I have my K3 and just finishing installing my SteppIR small vertical > with the SDA100 Controller and I also order the K3 Transceiver > interface connector from the > SDA100 Controller to the K3. > > Does any one knows how is setp up : > I assume from the DATA IN/RADIO in the SDA100 Controller to the ? on the K3 ? > > Thank you and 73 > > Juan Carlos Munoz. > TG9AJR ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
