Hi Look at following. Use RS232 connector on K3 rear panel.
http://www.steppir.com/wp-content/uploads/2011/10/Transceiver-Interface-Operation-5-28-09.pdf 73 aki ja1nlx (2012/02/04 8:25), TG9AJR Juan Munoz wrote: > Sorry, forgot to mention that besides the K3 I also have hooked the P3 > and KPA500 > and the RS232 to USB for my computer. > > Do have available the ports on the KPA500, all the other ports on the > K3 and P3 are in used. > > Thanks. > > Juan Carlos Munoz. > TG9AJR > > > > > On Fri, Feb 3, 2012 at 5:01 PM, TG9AJR Juan Munoz<[email protected]> wrote: >> I have my K3 and just finishing installing my SteppIR small vertical >> with the SDA100 Controller >> and I also order the K3 Transceiver interface connector from the >> SDA100 Controller to the K3. >> >> Does any one knows how is setp up : >> I assume from the DATA IN/RADIO in the SDA100 Controller to the ? on the K3 ? >> >> Thank you and 73 >> >> Juan Carlos Munoz. >> TG9AJR > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:[email protected] > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
