Well, everything went fairly well up to the part III alignment. I was able to get slightly over 2 watts during the first few steps of the alignment. However during the next steps, I get higher current than I should, and the max out is about 5.5 watts even with the current cal set to 3.5 amps.
3 watts = 1.1 amp 4 watts = 1.8 amps 5 watts = 2.4 amps I have checked and swapped power supplies, changed power cords, and set current cal to 3.5 amps, but the max output seems to be about 5.5 watts. I get "Hi Current" indication even with the current cal set to 3.5. I would appreciate any insight, I have visually checked everything of course and don't see any obvious problem.. I looked at the troubleshooting section , but it seems pretty generic, I'm hoping someone might have run into this problem before and could point me to the right area to check...Any ideas? Thanks Tim NZ8J _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
