Hey,
>From FAQ:
"""
Q: I created a bridge and added my Ethernet port to it, using commands
like these:
ovs-vsctl add-br br0
ovs-vsctl add-port br0 eth0
and as soon as I ran the "add-port" command I lost all connectivity
through eth0. Help!
A: A physical Ethernet device that is part of an Open vSwitch bridge
should not have an IP address. If one does, then that IP address
will not be fully functional.
You can restore functionality by moving the IP address to an Open
vSwitch "internal" device, such as the network device named after
the bridge itself. For example, assuming that eth0's IP address is
192.168.128.5, you could run the commands below to fix up the
situation:
ifconfig eth0 0.0.0.0
ifconfig br0 192.168.128.5
"""
Hope it helps,
_______________________________________________
discuss mailing list
discuss@openvswitch.org
http://openvswitch.org/mailman/listinfo/discuss
