I would like to setup a network where I would use a PC2 as a controller
a PC1 as a macine being controlled
openvswitch is already installed in PC1 I would like to know the steps
which I have to use in order to control the machine PC1 By PC2 via open
flow .
what are the ovs command which are needed to run on Pc2 to create a
datapath and what needs to be done on PC1 in order to control the switch
on PC2
DISCLAIMER:
-----------------------------------------------------------------------------------------------------------------------
The contents of this e-mail and any attachment(s) are confidential and
intended
for the named recipient(s) only.
It shall not attach any liability on the originator or NECHCL or its
affiliates. Any views or opinions presented in
this email are solely those of the author and may not necessarily reflect the
opinions of NECHCL or its affiliates.
Any form of reproduction, dissemination, copying, disclosure, modification,
distribution and / or publication of
this message without the prior written consent of the author of this e-mail is
strictly prohibited. If you have
received this email in error please delete it and notify the sender
immediately. .
-----------------------------------------------------------------------------------------------------------------------
_______________________________________________
discuss mailing list
discuss@openvswitch.org
http://openvswitch.org/mailman/listinfo/discuss
