Please read INSTALL.Linux and the ovs-vsctl man page. --Justin
On Dec 6, 2011, at 7:53 PM, Pankaj Rawat wrote: > I would like to setup a network where I would use a PC2 as a controller a PC1 > as a macine being controlled > openvswitch is already installed in PC1 I would like to know the steps which > I have to use in order to control the machine PC1 By PC2 via open flow . > what are the ovs command which are needed to run on Pc2 to create a datapath > and what needs to be done on PC1 in order to control the switch on PC2 > DISCLAIMER: > ----------------------------------------------------------------------------------------------------------------------- > > The contents of this e-mail and any attachment(s) are confidential and > intended > for the named recipient(s) only. > It shall not attach any liability on the originator or NECHCL or its > affiliates. Any views or opinions presented in > this email are solely those of the author and may not necessarily reflect the > opinions of NECHCL or its affiliates. > Any form of reproduction, dissemination, copying, disclosure, modification, > distribution and / or publication of > this message without the prior written consent of the author of this e-mail > is > strictly prohibited. If you have > received this email in error please delete it and notify the sender > immediately. . > ----------------------------------------------------------------------------------------------------------------------- > > _______________________________________________ > discuss mailing list > discuss@openvswitch.org > http://openvswitch.org/mailman/listinfo/discuss _______________________________________________ discuss mailing list discuss@openvswitch.org http://openvswitch.org/mailman/listinfo/discuss
