ya its a new one and sir y i'am i getting unknown key format even though i give addr=192.168.10.2 and the problem i'm facing is its showing me an error has cannot find as a single device.I have no clue the reason for that
Thanks and regards Sandhya On Mon, Oct 21, 2013 at 10:24 AM, Activecat <active...@gmail.com> wrote: > If that is a new USRP from factory then you don't need to update the > firmware. > > > > On Mon, Oct 21, 2013 at 12:51 PM, Sandhya G <sandhya4...@gmail.com> wrote: > >> Thanks for the reply. >> Well is that only problem so that i'm unable to communicate and should i >> need to update the firmware? >> >> >> Thanks and regards >> Sandhya.G >> >> >> On Mon, Oct 21, 2013 at 10:19 AM, Activecat <active...@gmail.com> wrote: >> >>> Your pc must have 1000Mbps port. The 10/100Mbps won't work. >>> An alternative is to connect a 10/100/1000 LAN switch between your pc >>> and the USRP. >>> >>> Rgds, >>> activecat. >>> >>> >>> On Mon, Oct 21, 2013 at 12:37 PM, Sandhya G <sandhya4...@gmail.com>wrote: >>> >>>> HI all, >>>> >>>> >>>> I have followed as per the instructions given in the webpage for set up >>>> of the Usrp N200/N210 but still i am unable to communicate between the >>>> hardware and host pc >>>> >>>> >>>> >>>> 1.I have set the static ip of the host pc to >>>> 192.168.10.1(ifconfig eth0 192.168.10.1). >>>> >>>> 2.Whenever i give the device address=addr=192.168.10.1 and run the grc >>>> i am getting the error has “*unknown key format*” >>>> >>>> 3.Whenever i ping 192.168.10.2 or use the command uhb_find_device i >>>> am getting warning as “*NO DEVICE FOUND* “ >>>> >>>> 4. Is that a must i have to upload the fpga and firmware images when >>>> using the device for the first time. >>>> >>>> 5.Sometimes i am getting an error like”* unable to find as single >>>> device”.* >>>> >>>> *6.*The* *host pc is supporting only 10/100MBPS .Is that the only >>>> problem so that i am unable to communicate with the hardware. >>>> >>>> >>>> >>>> Can anybody help me on this issue.Awaiting for your valuable reply >>>> >>>> >>>> Thanks in advance >>>> >>>> Sandhya.G >>>> >>>> _______________________________________________ >>>> Discuss-gnuradio mailing list >>>> Discuss-gnuradio@gnu.org >>>> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio >>>> >>>> >>> >> >
_______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
