On 06/27/2013 09:44 AM, Karan Talasila wrote: > Hi, > I am using a basic tx and basic rx daughterboard for transmission and > reception. The spec says basic tx and basic rx run from 0 to 250 MHz. But > when i run transmitter and check the uhd_fft at receiver, after 32 Mhz, > there is no signal. If i set the transmitter frequency in my flowgraph as > 33 MHz, I don't get a signal at 33 Mhz, But when i enter frequency as > -31Mhz in the uhd_fft i get a received signal on my fft. why does this > happen? If it's in the range of daughter board it should be receiving it at > that particular frequency right. > >
Can you tell me more about the cabling setup? Which ports of the Basic TX and RX are you using, and how are they connected via SMA cable? -josh > > _______________________________________________ > Discuss-gnuradio mailing list > Discuss-gnuradio@gnu.org > https://lists.gnu.org/mailman/listinfo/discuss-gnuradio > _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
