Hi,
      I am using a basic tx and basic rx daughterboard for transmission and
reception. The spec says basic tx and basic rx run from 0 to 250 MHz. But
when i run transmitter and check the uhd_fft at receiver, after 32 Mhz,
there is no signal. If i set the transmitter frequency in my flowgraph as
33 MHz, I don't get a signal at 33 Mhz, But when i enter frequency as
-31Mhz in the uhd_fft i get a received signal on my fft. why does this
happen? If it's in the range of daughter board it should be receiving it at
that particular frequency right.

-- 
Regards
Karan Talasila
_______________________________________________
Discuss-gnuradio mailing list
Discuss-gnuradio@gnu.org
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio

Reply via email to