Dahhhhhhhhhhhhhhhh! thanks Achilleas
On Sun, Oct 24, 2010 at 11:54 AM, Tom Rondeau <trondeau1...@gmail.com> wrote: > On Sun, Oct 24, 2010 at 11:35 AM, Achilleas Anastasopoulos > <anas...@umich.edu> wrote: >> yes, i can run all the tests in the different example directories. >> >> However i cannot find/run grc >> >> Achilleas > > > "grc" was changed a bit back to "gnuradio-companion" because of a > naming conflict. Is that available? > > Tom > > > >> On Sun, Oct 24, 2010 at 11:08 AM, Tom Rondeau <trondeau1...@gmail.com> wrote: >>> On Sun, Oct 24, 2010 at 10:48 AM, Achilleas Anastasopoulos >>> <anas...@umich.edu> wrote: >>>> I am trying a new build from the source tree on fedora 12. >>>> Configure gives the result shown at the end of the email. >>>> Make and make check complete fine, but sudo make install >>>> completes with the message: >>>> *** Post-Install Message *** >>>> Warning: python could not find the gnuradio module. >>>> Make sure that /usr/local/lib64/python2.6/site-packages is in your >>>> PYTHONPATH >>>> >>>> make[3]: Leaving directory `/home/anastas/gnuradio_trunk' >>>> make[2]: Leaving directory `/home/anastas/gnuradio_trunk' >>>> make[1]: Leaving directory `/home/anastas/gnuradio_trunk >>>> >>>> I know the PYTHONPATH is set appropriately, since I can import gnuradio >>>> from within python... >>> >>> If you can import gnuradio, can you also run GNU Radio applications? >>> This might be a misunderstanding during the install but not an actual >>> problem. >>> >>> Tom >>> >>> >>> >>>> Also grc is not installed in /usr/local/bin >>>> >>>> Any ideas, >>>> Achilleas >>>> >>>> >>>> >>>> >>>> '********************************************************************* >>>> The following components were skipped either because you asked not >>>> to build them or they didn't pass configuration checks: >>>> >>>> usrp2-firmware >>>> >>>> These components will not be built. >>>> >>>> >>>> ********************************************************************* >>>> The following GNU Radio components have been successfully configured: >>>> >>>> config >>>> gruel >>>> gnuradio-core >>>> usrp >>>> usrp2 >>>> gr-usrp >>>> gr-usrp2 >>>> gr-msdd6000 >>>> gr-audio-alsa >>>> gr-audio-oss >>>> gr-atsc >>>> gr-cvsd-vocoder >>>> gr-gpio >>>> gr-gsm-fr-vocoder >>>> gr-noaa >>>> gr-pager >>>> gr-radar-mono >>>> gr-radio-astronomy >>>> gr-trellis >>>> gr-video-sdl >>>> gr-wxgui >>>> gr-qtgui >>>> gr-sounder >>>> gr-utils >>>> gnuradio-examples >>>> grc >>>> docs >>>> >>>> You my now run the make command to build these components. >>>> >>>> ********************************************************************* >>>> The following components were skipped either because you asked not >>>> to build them or they didn't pass configuration checks: >>>> >>>> gcell >>>> gr-gcell >>>> gr-audio-jack >>>> gr-audio-osx >>>> gr-audio-portaudio >>>> gr-audio-windows >>>> gr-comedi >>>> >>>> These components will not be built. >>>> >>>> Configured GNU Radio release v3.3.1git-92-gdd74b98a for build. >>>> >>>> _______________________________________________ >>>> Discuss-gnuradio mailing list >>>> Discuss-gnuradio@gnu.org >>>> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio >>>> >>> >> > _______________________________________________ Discuss-gnuradio mailing list Discuss-gnuradio@gnu.org http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
