On 12/7/2016 3:31 AM, Wenzhuo Lu wrote: > Add a function to configure vlan strip enable/disable for specific > SRIOV VF device. > > Signed-off-by: Chen Jing D(Mark) <jing.d.c...@intel.com> > ---
<...> > + > +/* Set vlan strip on/off for specific VF from host */ > +int > +rte_pmd_i40e_set_vf_vlan_stripq(uint8_t port, uint16_t vf_id, uint8_t on) > +{ > + struct rte_eth_dev *dev; > + struct i40e_pf *pf; > + struct i40e_vsi *vsi; > + > + RTE_ETH_VALID_PORTID_OR_ERR_RET(port, -ENODEV); > + > + dev = &rte_eth_devices[port]; > + pf = I40E_DEV_PRIVATE_TO_PF(dev->data->dev_private); > + > + if (vf_id > pf->vf_num - 1 || !pf->vfs) { > + PMD_DRV_LOG(ERR, "Invalid argument."); > + return -EINVAL; > + } > + > + vsi = pf->vfs[vf_id].vsi; > + > + if (vsi) > + return i40e_vsi_config_vlan_stripping(vsi, !!on); > + else if vd_if is valid, can vsi be NULL? If so this check may be required in some prev patches too. > + return -EINVAL; > +} > diff --git a/drivers/net/i40e/rte_pmd_i40e.h b/drivers/net/i40e/rte_pmd_i40e.h > index ca5e05a..043ae62 100644 > --- a/drivers/net/i40e/rte_pmd_i40e.h > +++ b/drivers/net/i40e/rte_pmd_i40e.h > @@ -187,4 +187,24 @@ int rte_pmd_i40e_set_vf_multicast_promisc(uint8_t port, > int rte_pmd_i40e_set_vf_mac_addr(uint8_t port, uint16_t vf_id, > struct ether_addr *mac_addr); > > +/** > + * Enable/Disable vf vlan strip for all queues in a pool > + * > + * @param port > + * The port identifier of the Ethernet device. > + * @param vf > + * ID specifying VF. > + * @param on > + * 1 - Enable VF's vlan strip on RX queues. > + * 0 - Disable VF's vlan strip on RX queues. > + * > + * @return > + * - (0) if successful. > + * - (-ENOTSUP) if hardware doesn't support this feature. Is this error type returned? > + * - (-ENODEV) if *port* invalid. > + * - (-EINVAL) if bad parameter. > + */ <...>