The default flow control settings for i225 should be set up as 'full'
for a request mode and do not depend from a NVM. '_set_default_fc_generic'
method took value from NVM and set a wrong default flow control settings.
Therefore driver up with none flow control settings.
Setting up '_fc_full' directly from a '_setup_link_generic' method and
solve this problem.
Signed-off-by: Sasha Neftin <sasha.nef...@intel.com>
Signed-off-by: Guinan Sun <guinanx....@intel.com>
---
drivers/net/e1000/base/e1000_mac.c | 4 +---
1 file changed, 1 insertion(+), 3 deletions(-)
diff --git a/drivers/net/e1000/base/e1000_mac.c
b/drivers/net/e1000/base/e1000_mac.c
index 0ae2a60d8..577ba9c1b 100644
--- a/drivers/net/e1000/base/e1000_mac.c
+++ b/drivers/net/e1000/base/e1000_mac.c
@@ -941,9 +941,7 @@ s32 e1000_setup_link_generic(struct e1000_hw *hw)
* based on the EEPROM flow control settings.
*/
if (hw->fc.requested_mode == e1000_fc_default) {
- ret_val = e1000_set_default_fc_generic(hw);
- if (ret_val)
- return ret_val;
+ hw->fc.requested_mode = e1000_fc_full;
}
/* Save off the requested flow control mode for use later. Depending
--
2.17.1
