Hi Nux, I may have encountered the same issue when using 4.3.0.1 with VMware + distributed switching. If it's the same issue then you might find that while an isolated network will have this problem, a VPC router will work fine. I've also found this issue to not occur with standard vSwitches.
Hope this helps. -----Original Message----- From: Nux! [mailto:n...@li.nux.ro] Sent: Tuesday, 19 August 2014 9:41 PM To: dev; us...@cloudstack.apache.org Subject: Re: VRouter sets the same public IP on 2 interfaces So the VR in the UI shows 3 NICs: isolated, control and public, but in SSH I see 4 NICs, of which eth2 and eth3 have the same IP settings and the SNAT is done on the wrong NIC (eth3 which doesn't seem to work, instead of eth2). Any ideas? Where is this VR taking it's settings exactly? -- Sent from the Delta quadrant using Borg technology! Nux! www.nux.ro ----- Original Message ----- > From: "Nux!" <n...@li.nux.ro> > To: "dev" <dev@cloudstack.apache.org>, us...@cloudstack.apache.org > Sent: Tuesday, 19 August, 2014 2:36:52 PM > Subject: Re: VRouter sets the same public IP on 2 interfaces > > I've added another zone and the problem is sadly very repeatable. :( > > -- > Sent from the Delta quadrant using Borg technology! > > Nux! > www.nux.ro > > > ----- Original Message ----- > > From: "Nux!" <n...@li.nux.ro> > > To: "dev" <dev@cloudstack.apache.org>, us...@cloudstack.apache.org > > Sent: Tuesday, 19 August, 2014 1:25:21 PM > > Subject: Re: VRouter sets the same public IP on 2 interfaces > > > > Right, so the SNAT on the VR is done on eth3 instead of eth2, not > > sure why this is happening. Can't spot anything dodgy in the logs. > > Once I remove the SNAT and add it on the eth2 (which has the same > > IP) then all my egress rules start to work again. > > > > I'll try to recreate the zone and hope this glitch goes away. > > > > > > > > -- > > Sent from the Delta quadrant using Borg technology! > > > > Nux! > > www.nux.ro > > > > > > ----- Original Message ----- > > > From: "Nux!" <n...@li.nux.ro> > > > To: "dev" <dev@cloudstack.apache.org>, us...@cloudstack.apache.org > > > Sent: Tuesday, 19 August, 2014 12:12:31 PM > > > Subject: VRouter sets the same public IP on 2 interfaces > > > > > > Hi, > > > > > > I have 4 networks defined (public, guest, storage and mgmt). It > > > looks like the VR sets up two internal NIcs (eth2 and eth3) for > > > connecting to the public network. It also sets the same IP address > > > on them. > > > Egress = Allow is also ignored and my VMs can't reach anything. > > > > > > Has anyone seen this before? I'm on 4.3 > > > > > > Thanks > > > > > > -- > > > Sent from the Delta quadrant using Borg technology! > > > > > > Nux! > > > www.nux.ro > > > > > > > > >
