Attached is the output of smartctl and screenshot. Dell XPS 1330 using Samsung HM250JI.
an...@anant-laptop:~$ sudo smartctl -a /dev/sda6 [sudo] password for anant: smartctl version 5.38 [i686-pc-linux-gnu] Copyright (C) 2002-8 Bruce Allen Home page is http://smartmontools.sourceforge.net/ === START OF INFORMATION SECTION === Device Model: SAMSUNG HM250JI Serial Number: S133JD0Q160378 Firmware Version: HS100-11 User Capacity: 250,059,350,016 bytes Device is: In smartctl database [for details use: -P show] ATA Version is: 7 ATA Standard is: ATA/ATAPI-7 T13 1532D revision 0 Local Time is: Tue Nov 3 06:37:03 2009 CST ==> WARNING: May need -F samsung or -F samsung2 enabled; see manual for details. SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 32) The self-test routine was interrupted by the host with a hard or soft reset. Total time to complete Offline data collection: ( 103) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 103) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 100 100 051 Pre-fail Always - 1 3 Spin_Up_Time 0x0007 252 252 025 Pre-fail Always - 2625 4 Start_Stop_Count 0x0032 097 097 000 Old_age Always - 37233 5 Reallocated_Sector_Ct 0x0033 252 252 010 Pre-fail Always - 0 9 Power_On_Hours 0x0032 098 098 000 Old_age Always - 1131 12 Power_Cycle_Count 0x0032 099 099 000 Old_age Always - 1036 191 G-Sense_Error_Rate 0x0032 041 041 000 Old_age Always - 596620 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 12 194 Temperature_Celsius 0x0022 154 085 000 Old_age Always - 28 (Lifetime Min/Max 7/51) 196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 58928 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 1569 198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 7428 199 UDMA_CRC_Error_Count 0x0036 252 252 000 Old_age Always - 0 200 Multi_Zone_Error_Rate 0x000a 252 252 000 Old_age Always - 0 SMART Error Log Version: 1 No Errors Logged SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 1127 - # 2 Short offline Completed without error 00% 1114 - # 3 Extended offline Completed without error 00% 1113 - # 4 Short offline Completed without error 00% 3 - # 5 Short offline Completed without error 00% 1 - SMART Selective Self-Test Log Data Structure Revision Number (0) should be 1 SMART Selective self-test log data structure revision number 0 Warning: ATA Specification requires selective self-test log data structure revision number = 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Interrupted [00% left] (0-65535) 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. an...@anant-laptop:~$ Anant ** Attachment added: "Palimpsest.png" http://launchpadlibrarian.net/35025339/Palimpsest.png -- palimpsest bad sectors false positive https://bugs.launchpad.net/bugs/438136 You received this bug notification because you are a member of Ubuntu Desktop Bugs, which is subscribed to gnome-disk-utility in ubuntu. -- desktop-bugs mailing list desktop-bugs@lists.ubuntu.com https://lists.ubuntu.com/mailman/listinfo/desktop-bugs
