---------- Forwarded message ----------
From: Lars Segerlund <[EMAIL PROTECTED]>
Date: 2008-jan-31 10:41
Subject: Re: Problems building xcb programs ...
To: Michel Dänzer <[EMAIL PROTECTED]>
I am trying to compile a VERY simple xcb program ... basicly a test
program which opens a window and draws in it.
gcc -o prog proc.c -lXCB
used to be enough to compile it, now it can't find any symbols (
normally from xcb.h ) that are used by xcb.
So I am missing something ...
/ Lars Segerlund.
2008/1/31, Michel Dänzer <[EMAIL PROTECTED]>:
>
> On Thu, 2008-01-31 at 08:40 +0100, Lars Segerlund wrote:
> >
> > I am running etch with some stuff from experimental.
> >
> > I have updated to libx11-6 from experimental and have the xcb-xxx-dev
> > 1.1 packages installed, but when I try to compile some programs which
> > used to compile just fine a lot of symbols are not found, ( all the
> > XCB<xxxxxx> ones ).
> > ( the progs also halt with libxcb.so.0 not found when run ... these
> > were built earlier ).
> >
> > I have done a find /usr/. -exec grep -l <symbolname> '{}' ';'
> > and concluded that these symbols are not defined anywhere in the
> > system ... this must mean that I am missing some dev package (
> > xcb-utils ??? ) or similar ...
> >
> > I really have googled and looked around but I can't figure out what's
> > missing.
> >
> > Please give me some hint :-D ... and please reply to this adress
> > since I am not on the list.
>
> It might have been better to post this upstream instead of here, but
> even then it would probably be hard to help without seeing exactly what
> you're trying to do and what happens.
>
>
> --
> Earthling Michel Dänzer | http://tungstengraphics.com
> Libre software enthusiast | Debian, X and DRI developer
>
