On 3/3/23, David Wright <deb...@lionunicorn.co.uk> wrote:
>
> Try removing the atheros module with:
>
> # rmmod ath10k_pci
>
> (check its name in /proc/modules), and then reload it with
>
> # modprobe ath10k_pci
>
> and check dmesg again.
Bingo! Those were the steps that enable me to see the wireless
network with nmtui ...
a) sudo rmmod ath10k_pci
b) cat /proc/modules | grep "ath10k_pci"
c) sudo modprobe ath10k_pci
d) sudo ip link:
$ sudo ip link
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: enp1s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc
pfifo_fast state DOWN mode DEFAULT group default qlen 1000
link/ether c0:3e:ba:26:aa:93 brd ff:ff:ff:ff:ff:ff
4: usb0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast
state UNKNOWN mode DEFAULT group default qlen 1000
link/ether de:79:31:21:04:06 brd ff:ff:ff:ff:ff:ff
5: wlp2s0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc noqueue
state DOWN mode DORMANT group default qlen 1000
link/ether 4e:0b:ec:22:77:bc brd ff:ff:ff:ff:ff:ff permaddr
5c:3a:45:0a:fb:c1
$
e) nmtui
I will retest all the steps when I get a chance to make sure to go
through the steps from a "blank slate", new start
