Dear all, I have Debian Etch connected to a HP printer through an USB
port but it is not recognized. A pair of months ago the printer worked
perfectly, and I could see it using "lsusb" command. After that I
disconnect the printer and now I connect it again to my Debian, but
"lsusb" command doesn't show anything about USB connections.
The output fromn "lshw" command is this:
*-usb:0
description: USB Controller
product: VT82xxxxx UHCI USB 1.1 Controller
vendor: VIA Technologies, Inc.
physical id: 7.2
bus info: [EMAIL PROTECTED]:07.2
version: 16
width: 32 bits
clock: 33MHz
capabilities: uhci bus_master cap_list
configuration: driver=uhci_hcd latency=32
resources: ioport:c400-c41f irq:3
*-usb:1
description: USB Controller
product: VT82xxxxx UHCI USB 1.1 Controller
vendor: VIA Technologies, Inc.
physical id: 7.3
bus info: [EMAIL PROTECTED]:07.3
version: 16
width: 32 bits
clock: 33MHz
capabilities: uhci bus_master cap_list
configuration: driver=uhci_hcd latency=32
resources: ioport:c800-c81f irq:3
How can I check where is my problem ???
Really thanks
alejandro.-
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
