On Sun, 2007-03-18 at 12:55 -0300, Alejandro wrote: > Dear all, I have Debian Etch connected to a HP printer through an USB > port but it is not recognized. A pair of months ago the printer worked > perfectly, and I could see it using "lsusb" command. After that I > disconnect the printer and now I connect it again to my Debian, but > "lsusb" command doesn't show anything about USB connections. > > The output fromn "lshw" command is this: > > *-usb:0 > description: USB Controller > product: VT82xxxxx UHCI USB 1.1 Controller > vendor: VIA Technologies, Inc. > physical id: 7.2 > bus info: [EMAIL PROTECTED]:07.2 > version: 16 > width: 32 bits > clock: 33MHz > capabilities: uhci bus_master cap_list > configuration: driver=uhci_hcd latency=32 > resources: ioport:c400-c41f irq:3 > *-usb:1 > description: USB Controller > product: VT82xxxxx UHCI USB 1.1 Controller > vendor: VIA Technologies, Inc. > physical id: 7.3 > bus info: [EMAIL PROTECTED]:07.3 > version: 16 > width: 32 bits > clock: 33MHz > capabilities: uhci bus_master cap_list > configuration: driver=uhci_hcd latency=32 > resources: ioport:c800-c81f irq:3 > > How can I check where is my problem ??? > > Really thanks > > alejandro.- > > Try a differant USB port? Perhaps the one you are using is broken. -- Matthew K Poer
-- To UNSUBSCRIBE, email to [EMAIL PROTECTED] with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
