Matthew K Poer wrote:
On Sun, 2007-03-18 at 12:55 -0300, Alejandro wrote:
Dear all, I have Debian Etch connected to a HP printer through an USB
port but it is not recognized. A pair of months ago the printer worked
perfectly, and I could see it using "lsusb" command. After that I
disconnect the printer and now I connect it again to my Debian, but
"lsusb" command doesn't show anything about USB connections.
The output fromn "lshw" command is this:
*-usb:0
description: USB Controller
product: VT82xxxxx UHCI USB 1.1 Controller
vendor: VIA Technologies, Inc.
physical id: 7.2
bus info: [EMAIL PROTECTED]:07.2
version: 16
width: 32 bits
clock: 33MHz
capabilities: uhci bus_master cap_list
configuration: driver=uhci_hcd latency=32
resources: ioport:c400-c41f irq:3
*-usb:1
description: USB Controller
product: VT82xxxxx UHCI USB 1.1 Controller
vendor: VIA Technologies, Inc.
physical id: 7.3
bus info: [EMAIL PROTECTED]:07.3
version: 16
width: 32 bits
clock: 33MHz
capabilities: uhci bus_master cap_list
configuration: driver=uhci_hcd latency=32
resources: ioport:c800-c81f irq:3
How can I check where is my problem ???
Really thanks
alejandro.-
Try a differant USB port? Perhaps the one you are using is broken.
Both USB ports don't respond....I have installed "udev" and not
"hotplug"....is this correct in Debian Etch in order to recognize USB
devices ???
Really thanks
Regards.
--
To UNSUBSCRIBE, email to [EMAIL PROTECTED]
with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
