Russell Coker wrote: boot=/dev/hda5
change to boot=/dev/hda fixed the problem...... Now it's on to X using XFree..... Thanks for the pointer to the doc... as I'm new to Debian > > On Mon, 9 Sep 2002 21:25, Designer wrote: > > I ran " lilo" after that. It looked ok, but I still get the > > > > L01 01 01 01 > > > > repeating (01) moniker.... > > >From /usr/share/doc/lilo/Manual.txt.gz: > > L <error> ... The first stage boot loader has been loaded and started, > but it can't load the second stage boot loader. The two-digit error > codes indicate the type of problem. (See also section "Disk error > codes".) This condition usually indicates a media failure or a geometry > mismatch (e.g. bad disk parameters, see section "Disk geometry"). > > [...] > Disk error codes > - - - - - - - - > > If the BIOS signals an error when LILO is trying to load a boot image, the > respective error code is displayed. The following BIOS error codes are > known: > > [...] > 0x01 "Illegal command". This shouldn't happen, but if it does, it may > indicate an attempt to access a disk which is not supported by the > BIOS. See also "Warning: BIOS drive 0x<number> may not be accessible" > in section "Warnings". > > -- > I do not get viruses because I do not use MS software. > If you use Outlook then please do not put my email address in your > address-book so that WHEN you get a virus it won't use my address in the > >From field. > > -- > To UNSUBSCRIBE, email to [EMAIL PROTECTED] > with a subject of "unsubscribe". Trouble? Contact [EMAIL PROTECTED]
