On Mon, 9 Sep 2002 21:25, Designer wrote:
> I ran " lilo" after that. It looked ok, but I still get the
>
> L01 01 01 01
>
> repeating (01) moniker....
>From /usr/share/doc/lilo/Manual.txt.gz:
L <error> ... The first stage boot loader has been loaded and started,
but it can't load the second stage boot loader. The two-digit error
codes indicate the type of problem. (See also section "Disk error
codes".) This condition usually indicates a media failure or a geometry
mismatch (e.g. bad disk parameters, see section "Disk geometry").
[...]
Disk error codes
- - - - - - - -
If the BIOS signals an error when LILO is trying to load a boot image, the
respective error code is displayed. The following BIOS error codes are
known:
[...]
0x01 "Illegal command". This shouldn't happen, but if it does, it may
indicate an attempt to access a disk which is not supported by the
BIOS. See also "Warning: BIOS drive 0x<number> may not be accessible"
in section "Warnings".
--
I do not get viruses because I do not use MS software.
If you use Outlook then please do not put my email address in your
address-book so that WHEN you get a virus it won't use my address in the
>From field.
