Stu:
Hope all is well.
My 42 Custom has the main traveler mounted over the
companionway, much like my 34 did. When C&C made boats with this type of
arrangement, the deck has molded fiberglass housings on both sides of the
companionway for mounting the traveler track. I was using the outboard end of
these fiberglass housings for my PA Fish and Boat Commission registration
stickers, which fit very nicely. Unfortunately, the PA boat police don’t like
that location and demanded that the stickers be placed at the bow. As a
result, I’m thinking about ordering a couple stickers to place on the ends of
the fiberglass housings with the C&C logo. I’m going to adjust it to put “42
Custom” underneath. You don’t sell anything like that, do you? Assuming you
don’t, below is a similar logo you sent re: a C&C 37 awhile back, and attached
is artwork that I copied from a lister’s e-mail. The problem with the artwork
is that it gets jagged edges when enlarged. Do you have any logo artwork that
stays intact when enlarged?
Please advise. Thanks.
Matt
<https://dl.airtable.com/.attachments/99435765c14508096f8a39194554552e/86880855/2022-04-0215.41.58.jpg>
<https://dl.airtable.com/.attachments/99435765c14508096f8a39194554552e/86880855/2022-04-0215.41.58.jpg>
C&C logo.docx
Description: MS-Word 2007 document
