or this: https://www.amazon.com/CRAFTSMAN-Impact-Driver-8-Inch-CMMT14104/dp/B07R96M9VW/ref=sr_1_9?crid=224QLOJ7DHJJH&dchild=1&keywords=impact+driver&qid=1610640081&sprefix=impact+driver%2Caps%2C172&sr=8-9
Joel On Thu, Jan 14, 2021 at 10:44 AM Dennis C. via CnC-List < cnc-list@cnc-list.com> wrote: > Good spot for one of these: > > https://www.amazon.com/GearWrench-85035-35-MicroDriver-Set/dp/B0062FSAVI > > Whereas I prefer an impact driver, this driver might also work. Has a > nice selection of bits. Select the proper size Phillips, place it in the > slots, apply loosening pressure and whack it with a hammer. > > This is my "go to" tool for a lot of jobs on the boat. I have 3 sets; > boat, truck, house. > > -- > Dennis C. > Touche' 35-1 #83 > Mandeville, LA > > On Thu, Jan 14, 2021 at 9:01 AM Debbie Jeffcoatt via CnC-List < > cnc-list@cnc-list.com> wrote: > >> we removed ours yesterday from 1984 C&C37 by inserting large phillips >> screwdriver bit tightly into head of screw, hitting it with a hammer >> (vertically into the mast) to help break the corrosion seal and at the same >> time using a vice-grip to apply turning pressure (CCW). It took a long time >> for my wife and i to get the first one done, but after that with more >> confidence and rapid hammer hits the next ones did not take so long. Make >> sure the screwdriver bit is large enough and tightly into the bolt head as >> you do not want to damage the phillips head or it is game over. Make sure >> you strike the bit aquarely into the head. suggest you clean off any oil >> around it to prevent slippage. >> Good luck! >> Jeff & Debbie J >> >> >> Thanks to all of the subscribers that contributed to the list to help > with the costs involved. If you want to show your support to the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > Thanks - Stu -- Joel
Thanks to all of the subscribers that contributed to the list to help with the costs involved. If you want to show your support to the list - use PayPal to send contribution -- https://www.paypal.me/stumurray Thanks - Stu
