I'm glad I'm not alone. I took mine apart a couple of years ago and cleaned it out. Cleaning the glow plug got me a couple of years of starting from battery power alone, but it's back to crawling out to start the motor now.
Jim Watts Paradigm Shift C&C 35 Mk III Victoria, BC On 24 November 2017 at 20:19, William Walker via CnC-List < cnc-list@cnc-list.com> wrote: > Thanks, that's what I do too. > Bill > > Sent from AOL Mobile Mail > ------------------------------ > On Friday, November 24, 2017 billbruce--- via CnC-List < > cnc-list@cnc-list.com> wrote: > Mine does the same...it's my practice to start the engine, than the > furnace, than shut the engine off after a bit. The Heater draws a lot of > power on the start cycle and unless you have a large house bank, it will > under power and fail to light off. > > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each and > every one is greatly appreciated. If you want to support the list - use > PayPal to send contribution -- https://www.paypal.me/stumurray > > > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each > and every one is greatly appreciated. If you want to support the list - > use PayPal to send contribution -- https://www.paypal.me/stumurray > > >
_______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
