Sometimes the application of some heat helps the prop let go. Put a wet rag over the cutlass bearing, otherwise it will get roasted. A small propane torch usually doesn't generate enough heat, but is worth a try.
Jake Jake Brodersen C&C 35 Mk-III "Midnight Mistress" Hampton VA From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Matthew L. Wolford via CnC-List Sent: Sunday, May 7, 2017 14:08 To: cnc-list@cnc-list.com Cc: Matthew L. Wolford <wolf...@erie.net> Subject: Stus-List Prop question Listers: I assume this has been covered before, but what is the best way to remove a 40-year old Martec folding prop from the shaft? The blades are off and the inside of the hub exposed, but the hub is not budging. Please advise. Thanks. Matthew L. Wolford 638 West Sixth Street Erie, PA 16507 (814) 459-9600 (Office) (814) 459-9661 (Fax) (814) 392-5599 (Cell) The information contained in this e-mail note and any attachments is intended for the personal and confidential use of the designated recipient(s). This communication may be an attorney-client communication, attorney work product, or otherwise privileged, confidential, or protected from disclosure under applicable law. If you are not the intended recipient or an authorized agent, you are hereby notified that you have received this communication in error, and that any review, dissemination, distribution, copying of, use of, or reliance upon this communication is prohibited. If you believe this communication was sent to you in error, do not read it. Please reply to the sender that you received the note in error and delete it. Thank you. Please consider the environment before printing this note.
_______________________________________________ This list is supported by the generous donations of our members. If you wish to make a contribution to offset our costs, please go to: https://www.paypal.me/stumurray All Contributions are greatly appreciated!
