Try it using a wheel puller, if that doesn't work, tighten it up as much as you
can, and hammer on the end of the (wheel puller) screw.
Regards,
Bill
-------- Original message --------
From: "Matthew L. Wolford via CnC-List" <cnc-list@cnc-list.com>
Date: 5/7/17 14:08 (GMT-05:00)
To: cnc-list@cnc-list.com
Cc: "Matthew L. Wolford" <wolf...@erie.net>
Subject: Stus-List Prop question
Listers:
I assume this has been covered before, but what is the
best way to remove a 40-year old Martec folding prop from the shaft? The
blades are off and the inside of the hub exposed, but the hub is not
budging. Please advise. Thanks.
Matthew L.
Wolford
638 West Sixth Street
Erie, PA 16507
(814) 459-9600 (Office)
(814) 459-9661 (Fax)
(814) 392-5599 (Cell)
The information
contained in this e-mail note and any attachments is intended for the personal
and confidential use of the designated recipient(s). This communication may be
an attorney-client communication, attorney work product, or otherwise
privileged, confidential, or protected from disclosure under applicable law. If
you are not the intended recipient or an authorized agent, you are hereby
notified that you have received this communication in error, and that any
review, dissemination, distribution, copying of, use of, or reliance upon this
communication is prohibited. If you believe this communication was sent to you
in error, do not read it. Please reply to the sender that you received the note
in error and delete it. Thank you.
Please consider the environment before
printing this note.
_______________________________________________
This list is supported by the generous donations of our members. If you wish to
make a contribution to offset our costs, please go to:
https://www.paypal.me/stumurray
All Contributions are greatly appreciated!
