Ours doesn't work at all it shows the wrong compass heading and gradually steers further and further off course until we're doing doughnuts. I've been wondering what to do with it. Jessica
On Saturday, September 10, 2016, dwight veinot via CnC-List < cnc-list@cnc-list.com> wrote: > It won't work well unless you have the rudder angle sensor installed I > tried to avoid getting down below to install that rudder angle sensor and > the unit just didn't work right until I spent many hours in a cramped space > and got it done been fine ever since. Also check the connections from the > flux gate compass on the back of the control head just pull each one off > and then connect it again and check your compass deviation as per the manual > > On Monday, September 5, 2016, Doug Welch via CnC-List < > cnc-list@cnc-list.com > <javascript:_e(%7B%7D,'cvml','cnc-list@cnc-list.com');>> wrote: > >> I have just acquired a new to me ST4000+ and am having trouble with the >> autopilot snaking through the water with each turn taking me farther off >> course. I hope this is a configuration issue and would appreciate any input >> on the correct settings. I have a 33-2. >> >> Thanks, >> Doug >> > > > -- > Sent from Gmail Mobile >
_______________________________________________ This list is supported by the generous donations of our members. If you like what we do, please help us pay for our costs by donating. All Contributions are greatly appreciated!
