PB Blaster, a bit of heat, and an impact wrench will usually remove most stuck fasteners…
Jake Jake Brodersen C&C 35 Mk-III “Midnight Mistress” Hampton VA From: CnC-List [mailto:[email protected]] On Behalf Of J Roger via CnC-List Sent: Tuesday, March 1, 2016 23:32 To: [email protected] Cc: J Roger <[email protected]> Subject: Re: Stus-List Prop nut I can't get mine off, any ideas? On Tue, Mar 1, 2016 at 5:45 PM, Dennis C. via CnC-List <[email protected] <mailto:[email protected]> > wrote: In my experience, propeller nuts should not be overly tight. They should be firmly snugged. If the hole for the cotter key doesn't line up, a new hole should be drilled in the shaft. A prop nut so installed should loosen easily. Opinions may vary on this depending on prop manufacturer's instructions. Dennis C. _______________________________________________ Email address: [email protected] <mailto:[email protected]> To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: [email protected] To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
