could the oil cooler be a tube in shell "heat exchanger"?
----- Original Message ----- From: "Jim Watts via CnC-List" <cnc-list@cnc-list.com> To: "1 CnC List" <cnc-list@cnc-list.com> Cc: "Jim Watts" <paradigmat...@gmail.com> Sent: Monday, January 18, 2016 8:44:30 PM Subject: Re: Stus-List Mixing elbow and Oil cooler concerns If it's a Yanmar, the mixing elbow should be considered a consumable. I replace ours every 1000 hours or so. I doubt the new one is stainless, they have been silver cast iron forever. I know nothing about oil coolers. Jim Watts Paradigm Shift C&C 35 Mk III Victoria, BC On 18 January 2016 at 15:15, Brian Fry via CnC-List < cnc-list@cnc-list.com > wrote: Was removing my mixing elbow for replacement, (weld is leaking). Has anyone had theirs rewelded? A new one is $225. I think the new one is stainless. At the same time I noticed rust along the bottom of the oil cooler. Is this an indication that the oil cooler is about to fail? C&C 37/40XL La Neige HdG Maryland _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com _______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
