If it's a Yanmar, the mixing elbow should be considered a consumable. I replace ours every 1000 hours or so. I doubt the new one is stainless, they have been silver cast iron forever. I know nothing about oil coolers.
Jim Watts Paradigm Shift C&C 35 Mk III Victoria, BC On 18 January 2016 at 15:15, Brian Fry via CnC-List <cnc-list@cnc-list.com> wrote: > Was removing my mixing elbow for replacement, (weld is leaking). Has > anyone had theirs rewelded? A new one is $225. I think the new one is > stainless. > At the same time I noticed rust along the bottom of the oil cooler. Is > this an indication that the oil cooler is about to fail? > > C&C 37/40XL > La Neige > HdG Maryland > > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
