You might consider giving this a try. If it works through the rest of the season then you might avoid the trouble of replacing the tank. I tried it on a new beckson port i put on my holding tank. I can't speak for the strength of the bond but i can tell you that the tank doesn't leak.
http://www.tapplastics.com/product/repair_products/adhesives_glues_sealants/tap_poly_weld_adhesive/435 Josh Muckley S/V Sea Hawk 1989 C&C 37+ Solomons, MD On Aug 28, 2015 4:42 PM, "Damian Greene via CnC-List" <cnc-list@cnc-list.com> wrote: > It looks like I'll need to replace the holding tank on my 1982 C&C 34 - > weeping crack in the sidewall at the discharge penetration (creating smelly > mess in the bilge). I could try to get it plastic-welded, but likely the > best route for a winter project will be to replace the tank, and the hoses > & 3-way valve while I'm at it. > > Replacement tanks were discussed some months back, but I'm not finding it > in the archive. > > So... > > Where do I get the tank dimensions (and I will confirm when I remove the > current tank). > > Where do I go to purchase a replacement tank? I remember a couple of > companies were recommended.Ideally someone who would have the tank as an > off-the shelf item? > > Thanks, > > Damian Greene > 1982 C&C 34 GHOST > Bass Harbor, Maine > > > > _______________________________________________ > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go to the > bottom of page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go to the bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
