Tom, if you can access the tubes with the heat exchanger in place. By all
means do so. Although when I do this on Pegasus, I run a lot of water through
it.
Doug MountjoysvPegasusLF38 just west of Ballard, WA.
------ Original message------From: Tom Buscaglia via CnC-ListDate: Sun, May 10,
2015 13:24To: cnc-list@cnc-list.com;Cc: Tom Buscaglia;Subject:Stus-List Heat
exchangerAs I progress through my cooling system I will have to clean out the
heat exchanger on our 3HM35. I have a simple question, not covered in the
repair manual I have...Can it be cleaned in place once the end caps are
removed? And, if so, does this mean I don't have the drain the coolant?thxTom
BuscagliaS/V Alera 1990 C&C 37+/40Vashon WAP
206.463.9200_______________________________________________Email
address:CnC-List@cnc-list.comTo change your list preferences, including
unsubscribing -- go to the bottom of page
at:http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com_______________________________________________
Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go to the bottom of
page at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
