The inboard side and ceiling were uninsulated on mine and when I re-did it I left them uninsulated. I used a "sound down" kit from jamestown distributing. I cut and dry fit the foam panels and used the included mylar tape to seal the raw edges. The kit came with tack down pins. They are aluminum and have a 2"x2" backer that is supposed to be nailed or screwed in place I epoxied them. The kit also came with a spray adhesive which I sprayed after the epoxy was dry. Push the foam over the tack pins and then install the mounting washers and caps. Seal all the corners with more mylar tape. Done.
Pictures upon request. Josh Muckley S/V Sea Hawk 1989 C&C 37+ Solomons, MD On Aug 26, 2014 12:32 PM, "Robert Hrabinsky via CnC-List" < cnc-list@cnc-list.com> wrote: > I have replaced the old, crumbling sound insulation in the accessible > parts of my engine compartment with new sound insulation from West Marine. > However, there is almost no room on either side of my Yanmar in my 30 MKII. > Getting new insulation in along the sides is going to be very difficult. I > am contemplating just taking out the old insulation from the sides of the > engine compartment and going without. Does anyone think this would be a big > mistake? > > _______________________________________________ > This List is provided by the C&C Photo Album > > Email address: > CnC-List@cnc-list.com > To change your list preferences, including unsubscribing -- go bottom of > page at: > http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com > > >
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
