Maybe same circuit as the running lights or bow light
_____ From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Joel Aronson via CnC-List Sent: July 13, 2014 11:42 AM To: Joe Della Barba; cnc-list@cnc-list.com Subject: Re: Stus-List binnacle light Not wired to the pull switch. That was for the old spotlight. The wire looks like it runs to the breaker panel. On Sunday, July 13, 2014, Joe Della Barba via CnC-List <cnc-list@cnc-list.com> wrote: Fair odds the pull switch went bad. Check for voltage on both sides of it. Joe Della Barba j...@dellabarba.com <javascript:_e(%7B%7D,'cvml','j...@dellabarba.com');> From: Joel Aronson [mailto:joel.aron...@gmail.com <javascript:_e(%7B%7D,'cvml','joel.aron...@gmail.com');> ] Sent: Sunday, July 13, 2014 6:28 AM To: Joe Della Barba; cnc-list@cnc-list.com <javascript:_e(%7B%7D,'cvml','cnc-list@cnc-list.com');> Subject: Re: Stus-List binnacle light Don I don't have a wiring diagram but there is a pull switch. I didn't check for voltage - yet. Thanks. Hope to see you on the Bay. I'm in south river. On Saturday, July 12, 2014, Joel Aronson <joel.aron...@gmail.com <javascript:_e(%7B%7D,'cvml','joel.aron...@gmail.com');> > wrote: Voltage. Bought new light thinking that was the problem but checked voltage first. Thanks On Saturday, July 12, 2014, Joe Della Barba via CnC-List <cnc-list@cnc-list.com> wrote: You need to fix the light. An external light will have all kinds of reflections. The wire is prone to chafe on the steering cables and where it goes into the compass. It is pretty much a trace it back to the start from the compass end and see what the problem is operation. Dumb question - did you measure the voltage or is there a chance the bulb died? Joe Della Barba j...@dellabarba.com <javascript:_e(%7B%7D,'cvml','j...@dellabarba.com');> Coquina From: CnC-List [mailto:cnc-list-boun...@cnc-list.com <javascript:_e(%7B%7D,'cvml','cnc-list-boun...@cnc-list.com');> ] On Behalf Of Joel Aronson via CnC-List Sent: Saturday, July 12, 2014 12:02 PM To: cnc-list@cnc-list.com <javascript:_e(%7B%7D,'cvml','cnc-list@cnc-list.com');> Subject: Stus-List binnacle light There is no power to my binnacle light. I've tried every breaker and switch. No luck. I can either trace the wiring back to the breaker or put a red LED in the navpod above the compass. Suggestions? -- Joel 301 541 8551 -- Joel 301 541 8551 -- Joel 301 541 8551 -- Joel 301 541 8551 _____ No virus found in this message. Checked by AVG - www.avg.com Version: 2014.0.4716 / Virus Database: 3986/7846 - Release Date: 07/13/14
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
