Not wired to the pull switch. That was for the old spotlight. The wire looks like it runs to the breaker panel.
On Sunday, July 13, 2014, Joe Della Barba via CnC-List < cnc-list@cnc-list.com> wrote: > Fair odds the pull switch went bad. Check for voltage on both sides of it. > > > > Joe Della Barba > > j...@dellabarba.com <javascript:_e(%7B%7D,'cvml','j...@dellabarba.com');> > > *From:* Joel Aronson [mailto:joel.aron...@gmail.com > <javascript:_e(%7B%7D,'cvml','joel.aron...@gmail.com');>] > *Sent:* Sunday, July 13, 2014 6:28 AM > *To:* Joe Della Barba; cnc-list@cnc-list.com > <javascript:_e(%7B%7D,'cvml','cnc-list@cnc-list.com');> > *Subject:* Re: Stus-List binnacle light > > > > Don > > > > I don't have a wiring diagram but there is a pull switch. I didn't check > for voltage - yet. Thanks. Hope to see you on the Bay. I'm in south river. > > On Saturday, July 12, 2014, Joel Aronson <joel.aron...@gmail.com > <javascript:_e(%7B%7D,'cvml','joel.aron...@gmail.com');>> wrote: > > Voltage. Bought new light thinking that was the problem but checked > voltage first. > > > > Thanks > > On Saturday, July 12, 2014, Joe Della Barba via CnC-List < > cnc-list@cnc-list.com> wrote: > > You need to fix the light. An external light will have all kinds of > reflections. The wire is prone to chafe on the steering cables and where it > goes into the compass. It is pretty much a trace it back to the start from > the compass end and see what the problem is operation. Dumb question – did > you measure the voltage or is there a chance the bulb died? > > > > Joe Della Barba > > j...@dellabarba.com <javascript:_e(%7B%7D,'cvml','j...@dellabarba.com');> > > > > Coquina > > *From:* CnC-List [mailto:cnc-list-boun...@cnc-list.com > <javascript:_e(%7B%7D,'cvml','cnc-list-boun...@cnc-list.com');>] *On > Behalf Of *Joel Aronson via CnC-List > *Sent:* Saturday, July 12, 2014 12:02 PM > *To:* cnc-list@cnc-list.com > <javascript:_e(%7B%7D,'cvml','cnc-list@cnc-list.com');> > *Subject:* Stus-List binnacle light > > > > There is no power to my binnacle light. I've tried every breaker and > switch. No luck. > > I can either trace the wiring back to the breaker or put a red LED in the > navpod above the compass. > > Suggestions? > > > > -- > Joel > 301 541 8551 > > > > -- > Joel > 301 541 8551 > > > > -- > Joel > 301 541 8551 > -- Joel 301 541 8551
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
