Hi I have an st6002. I mounted the computer and flux gate compass under the chart table against the drawers. Knees don't reach them when sitting at the table. Computer close to the side and compass as close to the centre line as possible. It has worked well. I have the controller by the wheel were I can easily see and use it.
Don Sent from my iPad > On Jun 3, 2014, at 6:02 AM, Steven Winks via CnC-List <cnc-list@cnc-list.com> > wrote: > > Hi. I am planning to install a Raymarine X5 wheel pilot in my C&C 34+. Does > anyone have any advice on where best to install the computer and flux gate > compass? > > Thanks for any help. > > Steve Winks > Corsair VI > 1990 C&C 34+ > Midland, ON
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
