I have my fluxgate compass mounted low in the boat just after of the mast under the settee near center line.I have the control computer mounted in a pod on the Binnacle guard.same pod also has my gps chartplotter.I find these to be good locations on my 35 MKII.I like to have the control where I can see rudder angle and heading, a remote control would be useful at times but I do not have one and there is little to interfere with the compass in that location.mine is an ST 4000 MKII plus, not that much different than the newer X5
_____ From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Steven Winks via CnC-List Sent: June 3, 2014 10:03 AM To: cnc-list@cnc-list.com Subject: Stus-List Raymarine X5 auto pilot installation C&C 34+ Hi. I am planning to install a Raymarine X5 wheel pilot in my C&C 34+. Does anyone have any advice on where best to install the computer and flux gate compass? Thanks for any help. Steve Winks Corsair VI 1990 C&C 34+ Midland, ON
_______________________________________________ This List is provided by the C&C Photo Album Email address: CnC-List@cnc-list.com To change your list preferences, including unsubscribing -- go bottom of page at: http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
