Rob, I have to tackle the same job on my 32. If I get to it before you I'll
be sure to send you pics.

Steve
Suhana, C&C 32
Toronto



On Wed, May 21, 2014 at 7:27 PM, Josh Muckley via CnC-List <
cnc-list@cnc-list.com> wrote:

> I didn't have to do it but could have when I was replacing the shift and
> throttle control cables.  I don't recall anything besides the tight space.
> On mine there is a shift lever "block" between the compass and the
> pedistal.  It is removable after disconnecting the control cables.
> Removing it makes everything easier.
>
> Josh Muckley
> S/V Sea Hawk
> 1989 C&C 37+
> Solomons, MD
>  On May 21, 2014 6:17 PM, "Robert Abbott via CnC-List" <
> cnc-list@cnc-list.com> wrote:
>
>> Has anyone installed an Edson Wheel Brake Replacement Kit?
>>
>> When I remove the Danforth compass and look down at where the new kit
>> should go, I wonder if this is a DIY job?
>>
>> Reminds me of replacing my mixing elbow.....if you were doing it on a
>> work bench, no big deal.....doing it in the constricted space is a
>> challenge.
>>
>> If anyone has done it or knows how to do it, what happens after the
>> compass is removed?  Any and all advice welcomed.
>>
>> Rob Abbott
>> AZURA
>> C&C 32 - 84
>> Halifax, N.S.
>>
>>
>> _______________________________________________
>> This List is provided by the C&C Photo Album
>>
>> Email address:
>> CnC-List@cnc-list.com
>> To change your list preferences, including unsubscribing -- go bottom of
>> page at:
>> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
>>
>>
> _______________________________________________
> This List is provided by the C&C Photo Album
>
> Email address:
> CnC-List@cnc-list.com
> To change your list preferences, including unsubscribing -- go bottom of
> page at:
> http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com
>
>
>
_______________________________________________
This List is provided by the C&C Photo Album

Email address:
CnC-List@cnc-list.com
To change your list preferences, including unsubscribing -- go bottom of page 
at:
http://cnc-list.com/mailman/listinfo/cnc-list_cnc-list.com

Reply via email to