Absolutely. I think that hours of heat on that hose/mixer elbow
connection makes it impossible to remove without cutting it off. I keep
a section of 2" exhaust hose stuck in the back of the boat, just in case
I need to do it again. Maybe next time I'll try some Permatex #2 gasket
sealant, which handles extended high temps without getting crusty.
There's always something new to try and figure out.
Wal
John Russo wrote:
The hardest part was the short hose interfacing
the elbow with the muffler and I had a problem removing and reconnecting.
There doesn't appear to be any short cuts unless you are willing to cut off
the interface hose and replace it with a new one.
_______________________________________________
This List is provided by the C&C Photo Album
http://www.cncphotoalbum.com
CnC-List@cnc-list.com
