Ditto that and additionally I found the bracket which holds the cable was bolted on too tight which also restricted operation. Same was true with my throttle cable.
Derek 33 Mark II - Melan : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : : Derek Leck : : Account Manager METZGERS : : www.metzgers.com<http://www.metzgers.com> 419.861.8611 x4824 : : fax: 419.861.3299 [http://www.metzgers.com/misc/EmailSig.jpg]<http://www.metzgers.com/social-media> From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Michael Clow Sent: Wednesday, August 28, 2013 9:03 AM To: cnc-list@cnc-list.com Subject: Re: Stus-List 1981 30MK1 Shifting problem with the 2gm20F We had a similar problem with our 2GM15 and we removed the cable and lubricated. Another major aspect was that the bracket holding the cable near the transmission shift lever was not properly aligned. Once we did these two things is was very smooth. Michael Clow Desire<http://desiresailing.org/>, C&C 32, Lake St. Clair From: CnC-List [mailto:cnc-list-boun...@cnc-list.com] On Behalf Of Rich Knowles Sent: Tuesday, August 27, 2013 9:25 PM To: cnc-list@cnc-list.com<mailto:cnc-list@cnc-list.com> Subject: Re: Stus-List 1981 30MK1 Shifting problem with the 2gm20F Sounds to that your cable, good as it feels when unloaded, may be quite worn internally and is binding as soon as you load it up. I suggest replacing it. Rich Knowles Indigo - C&C LF38 Halifax - Nova Scotia On 2013-08-27, at 21:46, Curtis <cpt.b...@gmail.com<mailto:cpt.b...@gmail.com>> wrote: 2gm20F sorry.. With the to lever push pull cable. Wheel steering. Right side throttle, Left side Trans shifter On Tue, Aug 27, 2013 at 8:38 PM, Curtis <cpt.b...@gmail.com<mailto:cpt.b...@gmail.com>> wrote: I have just installed a new tome engine in my 30MK1 The shift cable is good condition. Disconnected from the shift lever, I get smooth action all the way threw the stroke. The shift lever on the tranny smooth as well, But when I hook them up it takes a lot of pressure to move? The old engine I just took out was a bit hard to shift as well? Any help on this would be great. Has anybody had this problem? I need help. I have spent 4 evenings working on it moving it around trying to re-adjust it. I'm at my end?? Help... Thanks, lt -- “Sailors, with their built in sense of order, service and discipline, should really be running the world.” - Nicholas Monsarrat _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com<mailto:CnC-List@cnc-list.com> -- “Sailors, with their built in sense of order, service and discipline, should really be running the world.” - Nicholas Monsarrat _______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com<mailto:CnC-List@cnc-list.com>
_______________________________________________ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com
